MADAS手动复位电磁阀
马达斯MADAS气体手动复位电磁阀，可用于常开和常闭。
常开：
它关闭从气体检测器接收信号，只能在建立后重新设置，并避免导致气体检测器干扰的泄漏。
重要事项：必须连接到气体检测器，而不是连续地产生脉冲信号。
常闭：
只有当电磁阀的电连接器上的LED始终打开时，才被视为安全装置。
它无张力（黑色）闭合或从气体检测器接收信号。
如果关闭是由于断电导致的，电磁阀可以重新设置为使用国内用户（例如炉子）。
在这种情况下，您没有处于安全状态，但是当张力回升时，电磁阀关闭并准备好复位并进行安全装置的功能。
如果关闭是由于气体检测器信号，则电磁阀只能在建立后被复位，并排除导致气体检测器干预的泄漏。
只需为线圈供电就不会打开阀门。复位机构必须手动操作（参见手动复位）。
参考标准EN 161
MADAS手动复位电磁阀

M16/RMO NA/NC
P.MAX 6 BAR

Gas manual reset solenoid valve that can be used both as normally open and as normally closed.

Normally open:
It closes receiving the signal from gas detector and can be reset only after founded and escluded the leakage that caused the gas detector intervention.
importANT: it must be connected to a gas detector that gives impulse signal, not continuously.

Normally closed:
It must be considered safety device only when the led on the electric connector of the solenoid valve is always on.
It closes without tension (black-out) or receiving the signal from gas detector.
If the closing is due to black-out the solenoid valve can be however reset to use domestic users (for example stoves). 
In this case you are not in safety condition but when tension comes back the solenoid valve closes and it is ready to be reset and to do the safety device function.
If the closing is due to a gas detector signal the solenoid valve can be reset only after founded and escluded the leakage that caused the gas detector intervention.

Simply powering the coil does not open the valve. The reset mechanism has to be operated by hand (see MANUAL RESET).

Reference standard EN 161

MADAS手动复位电磁阀